[tonimega_PT]

Hello good afternoon,
I took my original alarm ktm 60112035000 from my duke 390 2020 and the alarm worked normally, as defined, when activating, it blinked 4 blinks and gave a sound, when deactivating it blinked 4 blinks and gave a sound.
When active, the tft display would flash a red light. If you put the key and turn it to ON, the motorbike had the current cut by the alarm, if the alarm is deactivated, the motorbike was immediately with current and ready to start.

When I stopped the motorcycle, the alarm light on the tft always flashed once.

I just bought a duke 890 2022 and put the alarm on, and it has the same problem described here in the posts.

When activating with the command, the 4 blinks and beeps, only the red light on the tft does not blink, saying that the alarm is active. If you put the key in on, the bike always has current, ready to work, the difference between the duke 390 is that it doesn't cut the current to the engine.

When deactivating with the remote control, all 4 flashers flash and beep.

The difference is that it does not signal the alarm status in the tft and does not cut the current to the motor when active. I believe that the problem is the bike's software, as both the 790 and 890 have the same problems, being an original alarm for the bike, everything was working normally.