I'm stumped, I can't find the **** thing. I've already put LED signals on the bike, so it's not flashing. Since it's not flashing, I can't track it down by sound. My bad. Can anyone point me to where they hid the thing so I can swap it out?
Anyone had this problem or aware of it? It seems my brake lights are always on, at least there is no change in the light if either brake is actuated, unless the front brake springs then the light dips off for a millisecond. Will get on to the dealer as it's only a day old but wondered if there...
So im about to purchase yoshimura turn signals for the rear of my bike, i plan to buy some for the front when my budget allows it. Do i need a resistor kit to only run LED's on the rear? ive read mixed things on it and it seems to depend on the signals.
I read in one of the forums on here that...
U.S. Spec Bike.
I have read all of the other LED Signals threads and have yet to come up with an answer, so I needed to make my own.
I installed an MNNTHBX Tail Tidy first, without the resistors, and everything worked as it should except I get an error when using them. Doesn't bother me...
Here's my review of a selection of Rizoma accessories, including my as yet unresolved turn signal error messages.