Plugging holes after removing passenger footrest
1 - 6 of 6 Posts
Joined
·
253 Posts
I put these on https://www.satoracing.com/racinghook_hanger_ktm790duke.htm
Joined
·
119 Posts
No I'm going to keep them in case I want to put them back on. Good luck with your search.By the way, I'm in need of the stock passenger footrest. The whole unit. If you don't need it anymore, can I have it?
1 - 6 of 6 Posts
Join the discussion
Recommended Reading
-
Low rev smoothing?
KTM 790 Duke General DiscussionDid anybody ever come up with a definitive way to smooth out the 790 at low revs (other than buying an 890!) One that doesn't bring up an error message on the dash, won't cost an arm & a leg and genuinely makes a very noticeable difference (so, not a Booster Plug!)- 12
- 429
-
Where to buy Akrapovic dB killer/ baffle
KTM 790 Duke General DiscussionHello, First of all thanks to the admins and members for making this forum a great source of information on the 790/890. Does anyone know where I can buy a replacement dB killer / baffle for the 790 / 890 Akrapovic exhaust? Or if one is for sale by a forum member? Akrapovic said via email...- 0
- 44
-
790 Duke heat issue
KTM 790 Duke General DiscussionHi all, I picked up a new 2020 790 Duke yesterday. I'm beyond pleased with how it rides, but the thing gets damn hot! Does anyone else have issues with rider heat, and are there ways of mitigating this? How much of a reduction could I expect with the RS22 decat and ATOM setup?- 5
- 159
-
Brake upgrade round #3.
KTM 790 Duke General DiscussionFirst was better brake pads on the oem 790 calipers but not as good as brembos. Next was used Ducati 848 Brembo calipers and MC combo, which was huge improvement. Now for round #3 to complete the DIY 790R brake project is a new Pair of 320 rotors up front with some TI hardware and rear rotor...- 4
- 206
-
Thumper790 · updated
-
790 rider foot peg
KTM 790 Duke General DiscussionHello, any info on aftermarket pegs, with possible lowering potential will help my tired knees and also how to remove existing OEM pegs ? it appears you have to dismantle somethings to get at the pin.. any input will be appreciated- 21
- 3K
Join now to ask and comment!