[Dumbell123]

I ordered the MNNTHBX tail tidy for my 890 and was just curious if anyone had any pictures of how they wired it up since they only have a wiring chart on their site and no other instructions and I know very little about these kinds of things.

Thanks!

 

[LA_Stu]

I have the following diagram of how I did, from a previous question. Hope it helps you:

 

[Crackerguy]

Good diagram, I used these resistors:
R&G 21.5 Ohm

I added Rizomas in front as well, it is a good looking (if expensive) solution. Note that no additional resistors are needed for front signals with this setup.

 

[890 Dukerlooper]

Wow! I have been living with the error code when I used my turn signals. After following this diagram, I don't have an error message! Thanks!