KTM 790 Duke Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
7 Posts
Discussion Starter · #1 ·
Hi folks.
Just took my 790 for the 1st service and ran into issues during the sw update. The system would always fail at gear position sensor update phase with the error that 'the system is busy". The mechanic tried all sorts of things including shutdowns , reboots, battery disconnects etc etc but nothing helped. Now , i see now gear position indicator on the display (only N shows up for neutral). Has anyone faced anything like this?
Thanks!
 

·
Registered
Joined
·
7 Posts
Discussion Starter · #4 ·
Turns out , this was just an oddity about the gps update process. The process to follow when you see "ecu is busy" error is to simply retry 30 secs later. Should not power cycle the computer or the bike. And that worked just fine.
 
1 - 4 of 4 Posts
Top