KTM 790 Duke Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
81 Posts
Discussion Starter #1
First was better brake pads on the oem 790 calipers but not as good as brembos. Next was used Ducati 848 Brembo calipers and MC combo, which was huge improvement. Now for round #3 to complete the DIY 790R brake project is a new Pair of 320 rotors up front with some TI hardware and rear rotor. Hope all this fits as I had to reverse engineer measurements for what would work and fit from moto-master.

Should have installed tomorrow if it fits, fingers crossed.
 

Attachments

·
Registered
Joined
·
81 Posts
Discussion Starter #4
No except brake lines. The 848 calipers brembo m4 ti has banjo bolt toward inside so oem lines will not work. Plus MC has banjo bolt vertical from bottom instead of oem one being horizontal
 
1 - 5 of 5 Posts
Top