KTM 790 Duke Forum banner
1 - 7 of 7 Posts

Registered
2020 790 Duke
Joined
692 Posts
Discussion Starter · #1 · (Edited)
I need to get this out of my garage. Bought it to give it a try but decided to go back to stock exhaust.

To avoid any confusion this is a knock off/clone and not a genuine Akra slip on.

Low mileage, less than 30 miles on it. It has a removable DB killer so it does fairly loud and fairly quiet very nicely.

$20 plus you pay the shipping and you can be an owner.

Cylinder Automotive tire Automotive lighting Bumper Font
Camera accessory Cylinder Font Gas Auto part
Automotive exhaust Nickel Cylinder Muffler Auto part
Tire Automotive tire Wheel Synthetic rubber Helmet
 

Registered
2020 790 Duke
Joined
692 Posts
Discussion Starter · #3 ·
Yep still have it. The only issue on the install is stretching the springs in place. They are pretty strong. A pair of vice grips is needed.
 

a d m i n .
Joined
151,044 Posts
What a great idea. Don't have one in my tool box as I hardly ever work with springs.

A cheap harbor freight version might be a good addition.
I only found out about it when I bought a full exhaust for my then-new RC51, (back in 鈥00) and it came wt the kit from Moriwaki. ;)
 

Registered
Joined
257 Posts
Tie strap (or wire/tie wrap as some call it) is also pretty effective for pulling springs over. Can use screwdriver handle on far end for grip. Also avoids potential for scratch/injury if spring/hook slips.
 
1 - 7 of 7 Posts
Top